What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
11.06.2025 10:48

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
At one ohm, the resistor has a maximum of 1 watt power.
What are the best ways to treat seasonal allergies?
The bolt then partially travels down the line to your home.
He then asserts :
Here is a simplified AC power diagram.
Iconic ‘90s Actress, 52, Flaunts Figure in Black Swimsuit While Yachting - parade.com
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
There are three different concepts here that are getting confused.
This is where the MOV conducts again, and dissipated the energy.
Who are some of the best Korean Actresses?
Upvotes:
The MOV will conduct when the voltage exceeds 50% of line voltage.
He then describes the function of a fuse.
Have you ever had sex with your mother-in-law? If so, how was it and did your wife ever find out?
nine
I post the exact comment here.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
There are two important concepts here.
A circuit breaker is similar, but is resettable.
Asian Stocks Start Cautious, Dollar Holds Drop: Markets Wrap - Bloomberg
At least they know the answer if they wanted it.
This is 'the assistant's answer'
This one hit behind the barn.
Need a different reason to eat more fiber? How about microplastics? - The Seattle Times
But… the neutral is now “floating” because of the 1 ohm resistance.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Because the load is inductive, the current lags the voltage.(by a bit).
Can one still satisfy the desires of Black women with a more discreet endowment?"?
This is where this question deviates from being a 'generic' question, and becomes more specific.
An AC voltage/ current source, and an ac inductive load.
but this device (an Inductor) … impedes the rapid changes in the current.
This device then solves the entire problem.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Barnstars:
Resident Evil surprise return announced by PlayStation - GAMINGbible
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
These devices are installed between the “hot” and “neutral” and protective ground.
Six Types Of Dinosaur Eggs Found In One Place - The Daily Galaxy
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
(Dc diagram shown, AC is similar).
the problem then depends on "how fast does the fuse operate?".
2024–10–10[John johnson John Johnson ]
But it can get overloaded, and no longer works.
The third is lightning and “how it gets conducted into a home.”
One is “what exactly is in a ‘surge protector’ ? ”
[image of Common-mode choke]
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
It seems Mohan does not understand the difference between a comment and an Answer.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
In schematic diagrams this is the symbol for a fuse:
but I think this circuit , shows a few more pieces.
What does a fuse do?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
what exactly is a ‘surge’ protector?
so, what happens?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
[old diagram got deleted by accident]
a photo is worth a thousand words.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
These are simplified answers to the original question, and does not change anything I wrote above.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
So, the voltage could go up to 500 volts, and the fuse will not open up.
He then describes Rainy Season and Lightning.
A fuse is a non-resetable over current circuit protector.
For this case there are devices called Metal oxide varistors (MOV).
Now when you have a certain ac resistance, then a current flows in a loop.
The other is “what does a “fuse” do?”
eight
One
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
2024–10–16 [ OO OLAOYE OYEBODE ]
First Sentence:
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
It also is a device that limits the change in current flow.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
What is lightning?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Edit 2024–10.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.